TOOL · Power Tools
Router Bit
The shaped cutter that mounts in a router collet — bits come in profile, joinery, and template-following styles for nearly every shaping task.
6 guides are about this tool · 1 also reference it
Techniques
2How to Install a Router Bit (and the 1/8-inch Pullback Rule)
Insert the bit fully, pull back 1/8", tighten the collet to spec. The pullback rule prevents bit-bottoming damage and shank scoring; here's why it works.
- Router
- Router Bit
- Power Tool
Beginner · Updated May 12, 2026
Router Feed Rate: How to Tell If You're Too Fast or Slow
Too fast tears out wood and stalls the motor; too slow burns the cut. Three sensory cues — sound, chip size, surface — tell you the speed instantly.
- Router
- Router Bit
- Power Tool
Beginner · Updated May 12, 2026
Tool Guides
1References
1Troubleshooting
2Router Kickback: Why It Happens and How to Prevent It
Kickback is the bit grabbing the workpiece and throwing it. The cause is almost always feed direction. Three rules eliminate it on table or handheld.
- Router
- Router Table
- Router Bit
Beginner · Updated May 5, 2026
Why a Trim Router Can't Safely Run Large Bits
Trim routers spin at 30,000 RPM with no speed control. At that speed, any bit over 1" diameter exceeds safe tip speed and risks bit failure or burn.
- Trim Router
- Router
- Router Bit
Beginner · Updated May 12, 2026
Also Referenced in 1 Guide
Show all →
These guides mention the router bitin passing — comparison tables, "you could also use" lists, or single-sentence references — but aren't substantively about it.